Can-Am Alpina Club  

Go Back   Can-Am Alpina Club > General Discussion > General Discussion

General Discussion General Alpina talk

Site News
Latest 5 Posts Forum Author
Factory Pricelist for Alpina B6 Biturbo 2dr Coupe 02-16-2019 04:28 PM General Discussion marsfm
Seeking any VIN for LCI 2015-17 EU-Spec F13 Alpina B6 Biturbo 2-Dr Coupe 02-16-2019 04:19 PM General Discussion marsfm
Seeking PDF Parts Catalogue for EU-Spec F13 Alpina B6 Biturbo 2016-2017 02-16-2019 04:02 PM General Discussion marsfm
Alpina Replacement Keys? 02-13-2019 03:37 PM General Discussion Scooter
Alpina B8 #64 of 93 Limo 01-28-2019 08:47 AM General Discussion Scooter

Reply
 
Thread Tools Display Modes
  #81  
Old 05-30-2016, 09:15 AM
Stirling's Avatar
Stirling Stirling is offline
Administrator
 
Join Date: Dec 2011
Location: North Bay
Posts: 515
Thanks: 15
Thanked 9 Times in 9 Posts
Default

Nice work. I'm without a centre armrest in the B10 and I miss it.
  #82  
Old 05-30-2016, 07:01 PM
jrsmitchell jrsmitchell is offline
Member
 
Join Date: Aug 2012
Location: Mississauga, ON
Posts: 86
Thanks: 3
Thanked 1 Time in 1 Post
Default

Car looks great! I too really like the arm rest. Not sure why anyone prefers it without to be honest.
  #83  
Old 08-22-2017, 08:15 AM
Scooter's Avatar
Scooter Scooter is offline
Senior Member
 
Join Date: Jan 2012
Location: Burnaby, BC
Posts: 491
Thanks: 12
Thanked 5 Times in 5 Posts
Default

Not much to update here, but I took the car for a drive the other night and thoroughly enjoyed it! Sadly she hasn't been driven as much as I'd like this summer. Something on the front needs some work. I'm getting vibrations from the front right on braking. I don't think it's a warped rotor, but maybe it is. I just haven't had time to look into it.

The good news is that I'm moving in a few weeks and she will FINALLY get to live in a garage! I'm super excited about it. I've been waiting a long time to buy a house and store my car(s) in a garage. It will be especially nice to have a covered place to work on my cars. Hopefully, gone are the days of rolling around on the road next to and under the car and occasionally getting wet from rain or someone else washing their car down the road! It will also be nice to be able to stop work part way through a job rather than "needing" to finish in one day
  #84  
Old 01-24-2019, 12:24 PM
Scooter's Avatar
Scooter Scooter is offline
Senior Member
 
Join Date: Jan 2012
Location: Burnaby, BC
Posts: 491
Thanks: 12
Thanked 5 Times in 5 Posts
Default

Long time no update...I'm dealing with a fuel leak. Just waiting for new parts now. In the mean time, I found replacement door cards in pretty good shape. The Alpina wood trim is old, cracked and expensive to replace, so I got other inserts. A bit of glue coming undone on the inserts, but not bad. Replaced 3 of 4 last night. Before and after of one rear door below.





Slight difference on the front doors was the tweeter speaker was different (my car 1996, donor car 1992). I was able to swap them out, but in my car the speaker was a bit smaller, so I had to get it lined up just right to not show a gap on the edge.

Both door cards showing the different speakers:



Speaker swapped:



You can see the larger imprint from the original speaker.

Next on the list is to replace the driver's door handle including swapping the tumbler so I don't have two different keys. I'll do the door card swap at the same time. Then on to the fuel leak.
  #85  
Old 01-24-2019, 03:40 PM
Stirling's Avatar
Stirling Stirling is offline
Administrator
 
Join Date: Dec 2011
Location: North Bay
Posts: 515
Thanks: 15
Thanked 9 Times in 9 Posts
Default

Nice job on the door card. The door cards were always my nemesis on the B10. So hard to find replacements that weren't peeling too.
  #86  
Old 01-28-2019, 08:47 AM
Scooter's Avatar
Scooter Scooter is offline
Senior Member
 
Join Date: Jan 2012
Location: Burnaby, BC
Posts: 491
Thanks: 12
Thanked 5 Times in 5 Posts
Default

Thanks! Yeah, always tricky to find replacement interior parts for older cars.

I got a little over half way through the handle swap yesterday. Pic of old vs new, but I have already swapped the sensors over to the new handle.



So the whole issue was because of one little plastic piece on the linkage. You can see where it's missing on the picture below. If I had known that, I probably would have just tried to figure out a fix rather than buying a whole new handle. That would have saved me doing the tumbler swap.



Tumbler swap wasn't nearly as scary as I thought it was going to be, but it did highlight how worn out my key is. Old vs new:



You can see the waffers sticking out a little bit on the old one (right) compared to the new one. This made it a bit tricky to remove from the handle, and it also isn't working properly with the new handle, but it works ok with my spare key, so I'll just need to get a new key ordered and use my spare key for now.
Reply

Tags
alpina b8 4.6, bmw, fast, photo, saloon

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 02:30 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
vB.Sponsors